| Print |

Mesh
line
Assortment


STEEL WIRE MESH
TU U 28.7-36431800-017:2009

Welded steel mesh is produced acc. to TU U 28.7-36431800-017:2009 Mesh is produced from low carbon wire with mainly diameter 2,0 mm.
TYPE OF COATING:
- uncoated
- galvanized:
1. with zinc coating mass not less then 70 g/m2;
2. with zinc coating mass not less then 240 g/m2.

MESH CHARACTERISTIC BY CELLS SIZE:
Nominal cell size by wire axis, mm Nominal diameter of wire, mm Maximum deviation of cells size, mm
By vertical axis By horizontal axis Group 1 Group 2
1 2 3 4 5
16 16 1,8; 2,0 ±0,8 ±1,0
16 24 1,8; 2,0 ±0,8 ±1,0
20 20 1,8; 2,0 ±0,8 ±1,0
25 8 1,8; 2,0 ±0,8 ±1,0
25 12 1,8; 2,0 ±0,8 ±1,0
25 16 1,8; 2,0 ±0,8 ±1,0
25 25 1,8-3,0 ±1,0 ±1.0
25 50 1,8-3,0 ±1,0 ±1,0
50 25 1,8-3,0 ±1,0 ±1,0
50 50 1,8-4,5 ±1,5 ±1,5
50 75 1,8-5,0 ±1,5 ±1,5
50 100 1,8-5,0 ±1,5 ±1,5
75 50 1,8-5,0 ±1,5 ±1,5
75 75 1,8-5,0 ±1,5 ±2,0
100 50 1,8-5,0 ±1,5 ±2,0
250 50 2,0-5,0 ±1,5 ±2,0

Note 1. Acc. to customer's request the production of steel mesh with cells of other sizes and from wire of other diameters which was not stipulated in table is allowed. Max deviation of cells size for these cases has to correspond to max deviation for bigger size.
Note 2. Acc. to customer's request the production of steel mesh with variable cell sizes and from wire of different diameters in base of steel mesh is allowed.
Steel mesh is delivered in cards and rolls. The width of cards max 1200 mm, the length of cards max 3 m. The roll size: width — max 1600 mm; length of cell in roll — max 100 m. The number of pieces in one roll is max than three ones. The pieces of mesh are joined with a help of wire. Internal diameter of roll is max 150 mm. The rolls of mesh are binding over the circuit.

<<Assortment